How To Prepare, Clean And Sterilize The Bottle Step By Step
The bottle is being used less and less because most mothers prefer to breastfeed their baby. Those who use it find it difficult to follow the instructions to prepare the bottles well. In addition, it is difficult to find a guide explaining how is the correct way to clean them.
However, there are people who have lost the habit of sterilizing them, which is very serious for the baby. The hygiene conditions in these times, in most are not adequate, perhaps because they do not know how to do it or simply because it is very tiring to perform these procedures. For this reason, these steps are given to follow, very practical so that they are easy to carry out.
Bottle preparation
That one that there is no manual for raising children is totally true. Most of the main actions have to be learned with practice. Therefore, preparing a bottle is not that we have always known how to do it.
To prepare the bottle we must take into account a procedure that allows the well-being of the little one. The main indications are as follows.
- Use bottled water, it can be spring or mineral. Preferably without fluoride and low mineralization.
- Each type of formula contains instructions on the label. This refers to the amount of water and powder that we should use
- Put the measured powder in the warm water, not the other way around
- Mix well, or shake the bottle to remove most of the clumps
- Check the temperature of the milk by placing a few drops on your forearm, do not use your hands, because they are more resistant to heat.
Keep in mind that frequent and excessive bottle use has been shown to cause oral problems when it comes to tooth growth. The main option is always breastfeeding, once this is not feasible, complementary feeding must be introduced. The bottle should be a complement.
Steps to clean and sterilize the bottle
When preparing a bottle, you have to look at the following steps.
First step
Implements should always be handled with clean hands. Keep in mind that hand washing is one of the principles of food hygiene. Failure to comply with this premise can condition the appearance of poisoning. There are also different products that are effective for disinfection, according to a study published in the Journal of Food Protection.
Step two: sterilize
This is very important, before the baby uses the bottle for the first time, it is advisable to sterilize it. It is a prevention and safety method thinking about the well-being of the baby. After its first use, this action can be performed every two or three shots.
It is essential to wash them carefully with great thoroughness. The most common way to wash bottles is with soap and water. Some people use to sterilize it after each use.
Third step: clean
Just after each feeding, the bottle should be cleaned to prevent milk residue from adhering to the container. These residues are what can eventually generate bacteria.
The container, teat and lid must be washed separately with hot water, thoroughly rinsing with plenty of water. In this case you can use a special detergent for baby bottles, or else it could be a dishwasher.
Step four: using brushes to clean the bottle
After each part of the bottle has been carefully washed with soap and water, it is recommended to use special bottle brushes.
These brushes can get to all those hard-to-reach parts. The idea is to reach the places that could not be washed well in the previous step. Insisting mainly on the thread of the bottle as on the interior of the container and the nipple.
Fifth step: let dry
After cleaning the bottle, each part should be dried separately. This should be done in a clean place where air circulates. The proper advice is to leave the pieces down so that it drains and does not adhere to the container.
Step 6: put the bottle away
Finally, when each of the parts of the bottle is dry they can be stored in a clean place. A very important note, the assembled bottle should not be stored, preferably separately.
Clean bottle!
It can now be used for the next shot, these steps must be followed each time it is used. If the child is a newborn, it is preferable that it be sterilized after thoroughly washing it. It should be remembered that following these tips will take care of the baby’s well-being.
